File:Skylab - Smithsonian Air and Space Museum - 2012-05-15 (7275762424).jpg
Original file (1,168 × 2,000 pixels, file size: 903 KB, MIME type: image/jpeg)
Captions
Summary
[edit]DescriptionSkylab - Smithsonian Air and Space Museum - 2012-05-15 (7275762424).jpg |
Skylab space station and unfurled solar wing panel on display in the Smithsonian Air and Space Museum in Washington, D.C. This is an engineering back-up of the space station, which was never used. Skylab was a space station launched and operated by NASA. It consisted of the second stage of a Saturn IV-B rocket. Inside this stage was a second compartment, which formed a two-story area for work. The lower level contained the "Saturn workshop," while the upper area was a wardroom where eating, sleeping, physical exercise, and recreation could occur. Two huge solar panel arrays provided power to the station. A multi-section docking ring was attached to the station's nose, which allowed a traditional Command and Service Module unit to dock. Above the docking ring was the Apollo Telescope, a solar observatory. Disaster struck on launch day. Just 63 seconds into the flight, the micrometeoroid shield around Skylab ripped free from the space station. Just three seconds earlier, the rocket had passed Mach 1, and was passing through the "Max Q" -- the period of maximum atmospheric dynamic stress on the spacecraft. Rivets that didn't quite fit and seals which had not been totally completed allowed air to flow behind the shield at hypersonic speed. This caused the shield to partially deploy -- moving a few inches outward from the space station. The shield ripped almost completely free from the space station, unpeeling like the skin of a fruit. As the shield ripped away, it caused one of the solar panels to partially deploy -- and it ripped almost completely free of the space station. When the second stage separated from the space station at 9 minutes, 52 seconds into the flight, it fired retrorockets that allowed Skylab to move forward and away. These retrorockets, however, caused the damaged solar panel to rip completely free from Skylab. At about 21 minutes into the flight, the Apollo Telescope Mount successfully deployed. At 26 minutes into the flight, the solar panels were supposed to deploy. But the micrometeoroid shield was wrapped around the only remaining solar panel arm, and the deployment pyrotechnics shorted out trying to move too much weight. The micrometeoroid shield was designed to also function as a thermal shield. With this thermal shield gone, temperatures inside Skylab shot up to 225 degrees F. This weakened the skin of the space station, and NASA engineers refused to pressurize the station for fear that it would simply implode in orbit. The first manned mission to Skylab, known as Skylab-2, was due to launch for the space station on May 5, but this was pushed back to May 20 in order to give NASA time to figure out what to do. NASA engineers devised an umbrella-like device. This could be thrust out of the scientified airlock (an 8 inch by 8 inch opening designed to allow scientific instruments to be exposed to space but manipulated from inside the space station). By inserting a pole into the interior of the device, the "parasol" extended a 22 foot by 24 foot canopy made of gold nylon backed by metallized mylar. The astronauts had tried to free the trapped solar panel before docking, but failed. Three days later, after Skylab's batteries began to fail, another attempt was made -- this time via spacewalk. It nearly failed, but at the last moment the panel sprang free and fulled extended. (Skylab-3 would later deploy another parasol -- this one extended via two long arms -- on top of the first to help cool the station even further.) Skylab astronauts flew to the space station using the same command and service modules first developed for the lunar landings. The service modules were used to carry all the supplies the astronauts would need. At the end of the mission, the capsule (command module) would detach from the service module. The serivce module would burn up on re-entry, while the command module would splash down and return everyone to Earth safely. Only three manned missions were made to Skylab. The final mission ended in February 1974. Heating of the earth's atmosphere causes it to expand. This put added drag on Skylab. Without being boosted into a higher orbit, it would eventually crash back to earth. Although plans were made to do so, they did not get done in time. Skylab re-entered the earth's atmosphere over the Indian Ocean and Australia on July 11, 1979. Many pieces of the space station made it to the ground, some of them quite large! A one-fifth scale model of the Vostok 3KA, the craft that carried Yuri Gagarin into outer space, is visible at the bottom of the picture. |
Date | |
Source | Skylab - Smithsonian Air and Space Museum - 2012-05-15 |
Author | Tim Evanson from Cleveland Heights, Ohio, USA |
Licensing
[edit]- You are free:
- to share – to copy, distribute and transmit the work
- to remix – to adapt the work
- Under the following conditions:
- attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
- share alike – If you remix, transform, or build upon the material, you must distribute your contributions under the same or compatible license as the original.
This image was originally posted to Flickr by Tim Evanson at https://flickr.com/photos/23165290@N00/7275762424 (archive). It was reviewed on 11 February 2018 by FlickreviewR 2 and was confirmed to be licensed under the terms of the cc-by-sa-2.0. |
11 February 2018
File history
Click on a date/time to view the file as it appeared at that time.
Date/Time | Thumbnail | Dimensions | User | Comment | |
---|---|---|---|---|---|
current | 07:28, 11 February 2018 | 1,168 × 2,000 (903 KB) | Donald Trung (talk | contribs) | Transferred from Flickr via Flickr2Commons |
You cannot overwrite this file.
File usage on Commons
The following page uses this file:
Metadata
This file contains additional information such as Exif metadata which may have been added by the digital camera, scanner, or software program used to create or digitize it. If the file has been modified from its original state, some details such as the timestamp may not fully reflect those of the original file. The timestamp is only as accurate as the clock in the camera, and it may be completely wrong.
Camera manufacturer | Canon |
---|---|
Camera model | Canon EOS 5D Mark II |
Exposure time | 1/40 sec (0.025) |
F-number | f/3.5 |
ISO speed rating | 100 |
Date and time of data generation | 15:56, 15 May 2012 |
Lens focal length | 28 mm |
Width | 3,744 px |
Height | 5,616 px |
Bits per component |
|
Pixel composition | RGB |
Orientation | Normal |
Number of components | 3 |
Horizontal resolution | 72 dpi |
Vertical resolution | 72 dpi |
Software used | Adobe Photoshop CS5 Windows |
File change date and time | 18:12, 26 May 2012 |
Y and C positioning | Co-sited |
Exposure Program | Normal program |
Exif version | 2.21 |
Date and time of digitizing | 15:56, 15 May 2012 |
Meaning of each component |
|
APEX shutter speed | 5.375 |
APEX aperture | 3.625 |
APEX exposure bias | 0 |
Maximum land aperture | 3.625 APEX (f/3.51) |
Subject distance | 2.98 meters |
Metering mode | Pattern |
Flash | Flash did not fire, compulsory flash suppression |
DateTime subseconds | 48 |
DateTimeOriginal subseconds | 48 |
DateTimeDigitized subseconds | 48 |
Supported Flashpix version | 1 |
Color space | sRGB |
Focal plane X resolution | 3,849.2117888965 |
Focal plane Y resolution | 3,908.1419624217 |
Focal plane resolution unit | inches |
Custom image processing | Normal process |
Exposure mode | Auto exposure |
White balance | Auto white balance |
Scene capture type | Standard |
GPS tag version | 0.0.2.2 |
Serial number of camera | 620305364 |
Lens used | 28-300mm |
Date metadata was last modified | 14:12, 26 May 2012 |
Unique ID of original document | D78FB2BEE1F7A0B4CF02FDB88C8696EC |
IIM version | 3,936 |